8.1.4 Dew Point Temperature

Sensors for measuring dew point temperature can be particularly susceptible  to precipitation, wind, and radiation effects. Therefore, care should be taken in obtaining proper (manufacturer-recommended) shielding and aspiration equipment for the sensors. If both temperature and dew point are to be measured, aspirators can be purchased which will house both sensors. If measurements will be taken in polluted atmospheres, gold wire electrodes will minimize corrosion problems. For cooled mirror sensors consideration should be given to the susceptibility of the mirror surface to contamination.

8. QUALITY ASSURANCE AND QUALITY CONTROL
8.1 Instrument Procurement 
     8.1.1 Wind Speed 
     8.1.2 Wind Direction  
     8.1.3 Temperature and Temperature Difference 
     8.1.4 Dew Point Temperature 
     8.1.5 Precipitation 
     8.1.6 Pressure 
     8.1.7 Radiation  
 8.2 Installation and Acceptance Testing
     8.2.1 Wind Speed 
     8.2.2 Wind Direction  
     8.2.3 Temperature and Temperature Difference 
     8.2.4 Dew Point Temperature 
     8.2.5 Precipitation 
     8.2.6 Pressure
     8.2.7 Radiation
  8.3 Routine Calibrations  
      8.3.1 Sensor Check  
      8.3.2 Signal Conditioner and Recorder Check  
     8.3.3 Calibration Data Logs 
     8.3.4 Calibration Report  
     8.3.5 Calibration Schedule/Frequency 
     8.3.6 Data Correction Based on Calibration Results  
  8.4 Audits 
     8.4.1 Audit Schedule and Frequency  
     8.4.2 Audit Procedure 
     8.4.3 Corrective Action and Reporting 
  8.5 Routine and Preventive Maintenance 
     8.5.1 Standard Operating Procedures  
     8.5.2 Preventive Maintenance  
 8.6 Data Validation and Reporting  
     8.6.1 Preparatory Steps 
     8.6.2 Levels of Validation  
     8.6.3 Validation Procedures  
     8.6.4 Schedule and Reporting
  8.7 Recommendations