8.3.5 Calibration Schedule/Frequency

System calibration and diagnostic checks should be performed at six month intervals, or in accordance with manufacturer's recommendations, whichever is more frequent. The risk of losing data increases with the interval between operational checks. To reduce this risk, routine operational checks should be performed on a daily basis; these daily checks may be performed remotely. On-site inspections and maintenance should be performed on a weekly basis.

8. QUALITY ASSURANCE AND QUALITY CONTROL
8.1 Instrument Procurement 
     8.1.1 Wind Speed 
     8.1.2 Wind Direction  
     8.1.3 Temperature and Temperature Difference 
     8.1.4 Dew Point Temperature 
     8.1.5 Precipitation 
     8.1.6 Pressure 
     8.1.7 Radiation  
 8.2 Installation and Acceptance Testing
     8.2.1 Wind Speed 
     8.2.2 Wind Direction  
     8.2.3 Temperature and Temperature Difference 
     8.2.4 Dew Point Temperature 
     8.2.5 Precipitation 
     8.2.6 Pressure
     8.2.7 Radiation
  8.3 Routine Calibrations  
      8.3.1 Sensor Check  
      8.3.2 Signal Conditioner and Recorder Check  
     8.3.3 Calibration Data Logs 
     8.3.4 Calibration Report  
     8.3.5 Calibration Schedule/Frequency 
     8.3.6 Data Correction Based on Calibration Results  
  8.4 Audits 
     8.4.1 Audit Schedule and Frequency  
     8.4.2 Audit Procedure 
     8.4.3 Corrective Action and Reporting 
  8.5 Routine and Preventive Maintenance 
     8.5.1 Standard Operating Procedures  
     8.5.2 Preventive Maintenance  
 8.6 Data Validation and Reporting  
     8.6.1 Preparatory Steps 
     8.6.2 Levels of Validation  
     8.6.3 Validation Procedures  
     8.6.4 Schedule and Reporting
  8.7 Recommendations