8.2.4 Dew Point Temperature

A dew point temperature acceptance test at one point inside a building, where the rest of the system is being tested, will provide assurance that connections are correct and that the operating circuits are functioning. The dew point temperature for this test should be measured with a wet-dry psychrometer (Assman type if possible) or some other device in which some measure of accuracy is documented. If it is convenient to get a second point outside the building, assuming that the dew point temperature is different outside (usually true if the building is air conditioned with water removed or added), further confidence in the performance is possible. Of course, the manufacturer's methods for checking parts of the system (see the manual) should also be exercised.

8. QUALITY ASSURANCE AND QUALITY CONTROL
8.1 Instrument Procurement 
     8.1.1 Wind Speed 
     8.1.2 Wind Direction  
     8.1.3 Temperature and Temperature Difference 
     8.1.4 Dew Point Temperature 
     8.1.5 Precipitation 
     8.1.6 Pressure 
     8.1.7 Radiation  
 8.2 Installation and Acceptance Testing
     8.2.1 Wind Speed 
     8.2.2 Wind Direction  
     8.2.3 Temperature and Temperature Difference 
     8.2.4 Dew Point Temperature 
     8.2.5 Precipitation 
     8.2.6 Pressure
     8.2.7 Radiation
  8.3 Routine Calibrations  
      8.3.1 Sensor Check  
      8.3.2 Signal Conditioner and Recorder Check  
     8.3.3 Calibration Data Logs 
     8.3.4 Calibration Report  
     8.3.5 Calibration Schedule/Frequency 
     8.3.6 Data Correction Based on Calibration Results  
  8.4 Audits 
     8.4.1 Audit Schedule and Frequency  
     8.4.2 Audit Procedure 
     8.4.3 Corrective Action and Reporting 
  8.5 Routine and Preventive Maintenance 
     8.5.1 Standard Operating Procedures  
     8.5.2 Preventive Maintenance  
 8.6 Data Validation and Reporting  
     8.6.1 Preparatory Steps 
     8.6.2 Levels of Validation  
     8.6.3 Validation Procedures  
     8.6.4 Schedule and Reporting
  8.7 Recommendations